Matrix Orbital Corp

I bought the 204-25 and in order to short the gpo it says to make a jumper wire but the problem is is I do not have the place to connect the jumper wire.

there is supposed to be little connections to the right of the resistor but there are none. Does anyone know how to bypass this? Thanks

*shrugs* are there places or holes where it looks like there could be a soldered component? the ducoment you are reading might be written for an earlier revision of the hardware,, Henry any ideas?

you can remove the resistor and solder a wire in its place. Just be carefull, since if you draw more then 20mA you probably will damage the processor.