Matrix Orbital Corp

Polarsmurf,

Not sure what you are talking about. Now that You mention it, maybe the "Voice of God" was a bit much 'cause I seem to remember using aroung 470 ohms for most of my 5 volt LED powering in the past.

Can I just retract the whole thing and say "Use a meter"? Still, I couldn't too far off, and you should not actually damage a "classic" LED unless you REALLY abuse it! Blue and white are another matter. They don't even tolerate reverse bias.

best thing to say is "The Voice of the pig that lives down to road" ;p

i ment by, in the 20x4 -25pc , it has white led's, i was wondering what the width of them is because they fit into a grooved molding. thanks

If you see this post - http://www.lcdforums.com/forums/viewtop ... &forum=1&1 I replaced my flat white led with a round 5mm led. It fits very well (nice and tight)

Cheers,

r.

looks |337 if you dont mind me saying mr cheese

are you the same cheese off bit-tech?

Shak

On 2002-01-05 12:49, Shak wrote:
looks |337 if you dont mind me saying mr cheese

are you the same cheese off bit-tech?

Shak

As if there could be two

r.

edit - Just noticed where you're from, I lived in Batley until last year!

<font size=-1>[ This Message was edited by: TheCheeseMan on 2002-01-06 03:27 ]</font>

well, lots of people like cheese

Huddersfield Rocks just waiting for a MO shop here

Shak