Wow

Uncivil · Post by **Uncivil** » Mon Dec 22, 2003 7:29 pm

Wow I was excited to get my MX-222 USB display. After all the ordering and the expensive shipping it finally found its way to my house. I couldnt wait to get into the box. I got all of my goodies out of the box I laid it all out and started to tear my pc apart to install my new LCD. I read all over how great the MX 222 was. I asked around on the fourms and got great support. So I was ready to install this new goodie. Got it all in where it needed to go and tried to screw the screws in. Then I realised.....WTF am I supposed to do with a screw thats 1/4 of an inch long??? Heck the sides of my lexan case are that thick. Ohh well I will use a standard drive mount screw. WTF the threads are different. Its a coarse thread insert with a lil bitty short screw. Until I can figure out why you guys dont provide screws long enough to mount in my case I will be disappointed with this product. Any explanation?

Uncivil · Post by **Uncivil** » Mon Dec 29, 2003 9:09 pm

I guess the guys at MO cant respond to this?

Brillig · Post by **Brillig** » Mon Dec 29, 2003 11:04 pm

Ya, and me too! I want 12 inch screws because mine's mounted in a cinder-block case, and until I get a foot long screw, I'm not going to be happy either!

Uncivil · Post by **Uncivil** » Tue Dec 30, 2003 5:52 pm

be a smart ass if you must but I think a 1/4 inch screw is a little small. At least offer it in a standard drive threading