MX212 Still Won't Work
-
- LCD?
- Posts: 4
- Joined: Fri Jun 13, 2003 4:28 pm
- Location: MI
- Contact:
MX212 Still Won't Work
I downloaded lcdc and it couldn't be detected, even after i installed the usb drivers for it and it's recognized by my computer....?
Also i haven't registered it yet, it just came with a tag with my registration # on it, no cd or anything so what do i do?
Also i haven't registered it yet, it just came with a tag with my registration # on it, no cd or anything so what do i do?
-
- LCD?
- Posts: 4
- Joined: Fri Jun 13, 2003 4:28 pm
- Location: MI
- Contact:
If the USB driver is correctly installed, you should have an extra com port available to you (com3 or something) this is how LCDC will communicate with the MX2 device.
## # Mat # ##
LCDC - Drive it to the edge baby!
http://www.lcdc.cc
Matthew@DPS.uk.com
DPS Ltd. (Not MO!)
LCDC - Drive it to the edge baby!
http://www.lcdc.cc
Matthew@DPS.uk.com
DPS Ltd. (Not MO!)
-
- LCD?
- Posts: 3
- Joined: Sun Jun 08, 2003 8:31 pm
- Location: Blacksburg, VA
- Contact:
same problem
I am having the same problem with my MX212, i can get everything to install without a hitch except for the "USP Serial Port" which always installs with a little yellow exclamation point by it in the device manager. I also cant et my LCDC registered b/c i eneter the validation cade and it just sits there and doesnt proceeed to the next stage. I would appreciate the help alot. Thanks.
-
- LCD?
- Posts: 4
- Joined: Fri Jun 13, 2003 4:28 pm
- Location: MI
- Contact:
-
- LCD?
- Posts: 8
- Joined: Fri Jun 27, 2003 10:37 pm
- Contact:
I had this problem or one like it
I Had this problem at first too. It's your jumper settings. It seems as on the odd ocasion the jumpers are set on the wrong pins. You'll have to check the MO site more to find out which pins they are suppose to be, as i don't remember, hope this helps, goodluck