Help pluggin mx2 internally???

equilibrium · Post by **equilibrium** » Fri Oct 14, 2005 6:36 am

Can anyone help me i want to connect the mx2 internally on my msi k8n diamond but wasnt sure on how could someone help please?
Thanks
DAve

Miles · Post by **Miles** » Fri Oct 14, 2005 8:13 am

Hi equilibrium,

Thank you for contacting Matrix Orbital forums. First off, do you have an internal USB cable like the one shown here: http://www.matrixorbital.com/product_in ... munication

equilibrium · Post by **equilibrium** » Fri Oct 14, 2005 12:46 pm

Miles wrote:Hi equilibrium,

Thank you for contacting Matrix Orbital forums. First off, do you have an internal USB cable like the one shown here: http://www.matrixorbital.com/product_in ... munication

Hi Miles thanks for replying yes i have a internal usb cable as shown.
Thanks Dave

Tom · Post by **Tom** » Mon Oct 17, 2005 11:32 am

Hi equilibrium,

Here is the following configuration.

+5V goes to Vcc(Pin1)
D- goes to Data0-(Pin 3)
D+ goes to Data0+(Pin 5)
Gnd goes to Ground(Pin 7)

D- might be shown as something else like P- on your board, but the configuration will be the same.

If you have anymore questions or concerns, please feel free to post them.

Best Regards,

equilibrium · Post by **equilibrium** » Mon Oct 17, 2005 1:44 pm

Tom wrote:Hi equilibrium,

Here is the following configuration.

+5V goes to Vcc(Pin1)
D- goes to Data0-(Pin 3)
D+ goes to Data0+(Pin 5)
Gnd goes to Ground(Pin 7)

D- might be shown as something else like P- on your board, but the configuration will be the same.

If you have anymore questions or concerns, please feel free to post them.

Best Regards,

Hi
Thanks for your reply i will give it a go and see if not ill get back to you. Thanks for your help
DAve