LK162-12 Question

Bill_Sev · Post by **Bill_Sev** » Wed Apr 14, 2004 9:14 pm

In the datasheet section 2.1.7 its talks about setting to jumpers with the label I to enable I2C

To communicate by I2C two jumpers have to be set into the I2C position left of the power SIP connector. The
I2C setting is default on the LK162-12.

on the board I have r.210 there are no pads labeled I. Please advise!

Bill_Sev · Post by **Bill_Sev** » Thu Apr 15, 2004 12:12 pm

BUMP!

Miles · Post by **Miles** » Thu Apr 15, 2004 3:03 pm

I believe with PCB r.210 the SCL and SDA lines are dedicated to the microcontroller from the factory. This means if you look at the 4 pin connector it will be labeled as follows Vin, SCL, SDA, GND, this is where the connection is made!!