How do I mount the Temp Probes?

LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT Series

Moderators: Henry, Mods

Post Reply
jlhinrichs
LCD?
Posts: 6
Joined: Mon Nov 17, 2003 6:14 pm

How do I mount the Temp Probes?

Post by jlhinrichs »

What is the best way to mount the temp probes? I would like to mount them so their removeable and not perminately glued or fastened. I wanted to mount one to my ram, one to one of my harddrives, etc.. I was thinking maybe ATV silicon or something like that. I also have QuickSilver epoxy adhesive but that's pretty perminate.

Any ideas???

Jay :)
Top
Henry
OMNIPRESENT
OMNIPRESENT
Posts: 3014
Joined: Tue Aug 14, 2001 6:00 pm
Contact:
Contact Henry

Re: How do I mount the Temp Probes?

Post by Henry »

jlhinrichs wrote:What is the best way to mount the temp probes? I would like to mount them so their removeable and not perminately glued or fastened. I wanted to mount one to my ram, one to one of my harddrives, etc.. I was thinking maybe ATV silicon or something like that. I also have QuickSilver epoxy adhesive but that's pretty perminate.

Any ideas???

Jay :)
I used electrical tape... duct tape would work fine too...
Henry J.
President
Matrix Orbital
Top
Johnny
LCD Guru
Posts: 99
Joined: Fri Jan 16, 2004 3:01 am
Location: Out on $1.8 mill Bail
Contact:
Contact Johnny

Post by Johnny »

I would use 'heat proven tape'

Im sure electrical wouldnt melt but the glue on it can turn to a sticky goop at higher temps
I prefer to have a bottle in front of me than a full frontal Labotomy!

Check ma Bad, Invisible, Bail making Self!
Top
Post Reply

Return to “LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT”