GLK24064-25 Draw Bitmap from Memory
Posted: Wed Feb 05, 2020 11:56 am
Hello,
I've been having this issue for a week now, and haven't found an answer in the forums. So I'd like some light in the matter.
I am using MOGD# to script the following to the display (Draw a Bitmap from Memory)
254 98 1 0 0
But the display does not show the stored bitmap, and the next command sent to the display is not recognized as command but as Text.
For example,
If I script the command 254 98 1 0 0 it does nothing on the display, and then in the same MOGD# in drawings -> Graphics-> Click on Draw Bitmap
It starts showing a '6' character in the screen.
I've never seen this behaviour before, I've been using these displays for over ten years. I've always used the same command to show the bitmap.
Regards,
I've been having this issue for a week now, and haven't found an answer in the forums. So I'd like some light in the matter.
I am using MOGD# to script the following to the display (Draw a Bitmap from Memory)
254 98 1 0 0
But the display does not show the stored bitmap, and the next command sent to the display is not recognized as command but as Text.
For example,
If I script the command 254 98 1 0 0 it does nothing on the display, and then in the same MOGD# in drawings -> Graphics-> Click on Draw Bitmap
It starts showing a '6' character in the screen.
I've never seen this behaviour before, I've been using these displays for over ten years. I've always used the same command to show the bitmap.
Regards,