LK204-25 Blank Screen


Moderators: Henry, Mods

Post Reply
Posts: 1
Joined: Sun Nov 16, 2014 11:22 am

LK204-25 Blank Screen

Post by pmagee22 » Mon Nov 17, 2014 5:16 am

I'm using a LK204-25 to display information from a PLC it was working fine until last week when it stopped displaying any information. I removed it from the system and tried communicating to it wit Uproject which it appears I can do, the one thing I noticed is that if I try to change the contrast to the display nothing happens. I can change the brightness ok, it reports back the serial number and model type but the contrast does not respond. Is there anything someone can think of that would cause this issue.

Matrix Orbital
Matrix Orbital
Posts: 881
Joined: Fri Aug 17, 2007 10:58 am
Location: Matrix Orbital

Re: LK204-25 Blank Screen

Post by Clark » Mon Nov 17, 2014 9:47 am

Hi Pmagee,

If you haven't already, I would recommend that you try the manual override procedure listed in your manual to reset the unit to default settings.

However, given that you can communicate to the unit but are unable to change the contrast setting, your display may be damaged. If you can locate the serial number on the back of your unit (##M##-####) and forward that along with your shipping address to we can start the RMA process to have that unit analyzed and repaired.

Troy Clark
Design & Development
Matrix Orbital

Post Reply

Who is online

Users browsing this forum: No registered users and 19 guests