LED Indicator Bus on MX422


Moderators: Henry, Mods

Post Reply
Posts: 1
Joined: Sun Mar 09, 2014 4:52 pm

LED Indicator Bus on MX422

Post by JohnNewkirk » Sun Mar 09, 2014 4:56 pm

I have had a a MX232 for many years with a indicator bus connected to the GPOs for mail notifications. I recently replaed it with a MX422 with a new indicator bus that uses the ribbon cable. I cannot get any of the LEDs in the new bus to light for any of the events. Do I need to connect another power cable to the MX422 to power them?

Matrix Orbital
Matrix Orbital
Posts: 158
Joined: Wed May 22, 2013 9:04 am
Location: Matrix Orbital

Re: LED Indicator Bus on MX422

Post by Tino » Mon Mar 10, 2014 9:34 am

Hi John,

Thank you for posting here on our forums.

You should not have to connect another power cable to power the LED indicator.

Please check your connection and make sure it is connected properly.
Also check to be sure the LEDs are not dead.

When you first power the display do the LEDs flash at all?

If you have any other questions please feel free to ask.
Thank you
Martino DeLeon
Matrix Orbital
Technical Support Representative

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests