I attempted to move the jumpers from the rs232 square to the I2C square but made a mess of it, being inexperienced and having shaky hands.
There currently are no jumpers in any of the 5 squares.
What can I do to fix it? I want to run in I2C mode.
thanks
Phil M
LVK204-25 PCB V.3.0 -- messed up jumper move, any hope?
-
- LCD?
- Posts: 1
- Joined: Fri Jan 20, 2012 5:52 pm
Hi Phil,
The protocol resistors have a value of 0ohms; if you have removed them and all pads are intact you are in good shape. To bridge the connections for I2C, you can use a blob of solder on each of the two connections required, which should be easier than playing with those resistors.
Thanks,
Troy
The protocol resistors have a value of 0ohms; if you have removed them and all pads are intact you are in good shape. To bridge the connections for I2C, you can use a blob of solder on each of the two connections required, which should be easier than playing with those resistors.
Thanks,
Troy
Troy Clark
Design & Development
Matrix Orbital
Design & Development
Matrix Orbital