can the GPO be remapped?

LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT Series

Moderators: Henry, Mods

Post Reply
paulplasma
LCD?
Posts: 4
Joined: Mon Aug 17, 2009 6:49 am

can the GPO be remapped?

Post by paulplasma »

using a GLK19264 and have been successfully communicating with it for a few months now. I can switch any of the 3 LEDs to any red yellow green or off. But i have one display that was used early in my code development that saw lots of garbage characters and now 2 of the 3 LEDs do not respond properly. Basically wondering if I inadvertantly remapped the GPO or something???? Top LED stuck yellow, Mid LED works fine, Bot LED stuck off.

Ray
Matrix Orbital
Matrix Orbital
Posts: 742
Joined: Thu Dec 13, 2001 4:00 pm
Location: Earth.... I think..
Contact:

Post by Ray »

I'm not sure what could cause that but lets try restoring the unit to factory defaults. Please put on the manual override jumper (See manual for details) and use mogd# to upload the attached filesystem image to the unit. Once uploaded it will be with a bit of luck be back to normal.
Attachments
GLK19264-7T-1U.ebin
(16.46 KiB) Downloaded 308 times

Post Reply