Page 1 of 1
My Matrix Orbital display went dim?
Posted: Wed May 17, 2006 2:51 pm
by David97
I have the LK204-24-usb MX4 rev 1.0 and the other day it just went dim. You can still see the text if you look at it in a angle but it still looks dim. If you look at it stright you can hardly see any text.
In LCDC if i try to adjust the contrast or backlight intesity it does nothing.
Any ideas on what could be wrong? It is alomost 2 years old now i think but i can see the lights still work.
Posted: Wed May 17, 2006 3:32 pm
by David97
I just noticed that is i set the contrast and backlight intesity both to 100% i can see the text on the screen. If i use the recommended setting i can't see the text.
Posted: Wed May 17, 2006 4:35 pm
by David97
I found another thing wrong when i go to scan for dalles 1 wire probes it finds 205 of them! It don't matter if i have any installed or not. I tried a reinstall and it did the same thing.
I think my display has had it
Posted: Wed May 17, 2006 4:52 pm
by Tom
David,
Thank you for posting on the forum.
The display is old, since it's a version 1.0, so it will be out of warrantly. However, if you email me at
support@matrixorbital.ca, I will give you a couple options on this issue.
Best Regards,
Posted: Wed May 17, 2006 5:47 pm
by David97
ok email sent.
Posted: Wed Jun 07, 2006 1:02 pm
by Darrin
I have a similar problem with my LK202-24-USB. Same PCB revision, 1.0.
It's pretty much like David97's except the characters are all various symbols and solid blocks. Bummer.
