Joao,

I have replied to you via email.

Best Regards,

HI Joao,

Thank you for posting on the forum. Are you certain you have 12V applied to the device? If it was just 5V, you can get the same results you described.

Best Regards,

Glad to see you got it working. If you have anymore questions or concerns, please feel free to post them.

Best Regards,

Excellent, we all have that kid in us.

Once you have some specific questions, I will be happy to answer them.

Best Regards,

sheetssj, You may have an electrical noise problem. Although the cable is shielded, it isn't attached to earth ground, so the noise reduction isn't at maximum capacity, so you can possibly experience some interference. Try routing the cable as close to the case as possible. Or you can also pierce th...

Hi sheetssj,

Thank you for posting on the forum.

Are you using an internal or external usb cable?

DJ, Unfortunately, we currently don't have a manual for uproject, but I can answer any questions you have about uproject. To incorporate a custom character in the startup screen, you must create and save a custom character. The command for creating and saving a custom character is [254][194][memory ...

Hi DJJ123,

The programs do work fine, but what you will need to do when set up the startup screen is write to the display twice. You can try this, and it may help. I personally like using bootlogo for the start screens.

Best Regards,

Hi JBussman69,

Thank you for posting on the forum.

There is no manual for the B204A-BK, but I can tell you how to show you how to obtain use the keypad. First off, are you using it to replace the MX424 mount?

Hi Michael,

You can get the mechanical layout of the display on page 14 of the manual at http://www.matrixorbital.ca/manuals/MOP ... 12232D.pdf

If you have anymore questions or concerns, please feel free to post them.

Best Regards,

They are really quite easy to hook up. All you would need to do is refer to the data sheet. You can refer to figure 5 on page 17 of the max232 datasheet shown at http://pdfserv.maxim-ic.com/en/ds/MAX220-MAX249.pdf I hope this helps you out. If you have anymore questions or concerns, please feel free...

Unfortunately that revision is pretty old, so you'll need to do a lot more work on the display to have it communicate via TTL. It will require some cutting of traces and wiring to bypass the 232 chip. You will still need to have the 232 present for the contrast. I suggest you use a TTL to RS-232 con...

Hi Lake,

Please email me at support@matrixorbital.ca , and we'll get this matter resolved. In the email, please provide your first and last name, shipping information, and phone number.

Best Regards,

You will need the 550mA inrush current to drive the VFD. The VFD is not backlit though. The 290mA may be a typo on the website. I will get this straightened out. I apologize for any misconception this may have caused you. The operational current is approximately 70mA, but you should design for the m...

Make sure you get the metal part connected part of the jacket connected.

Best Regards,