I was hoping to tap on the 5vcc pin of the GPO header on my EGLK19264A-7T-FGW-VPT-PL unit to power a micro controller, but it appears to be open. I do not measure any voltage between pin 7 and any grounds.
Probing around, I measured 4.9vdc in one side or R77 and R75 solder pads, as both those ...
Search found 3 matches
- Wed Jun 05, 2024 1:23 pm
- Forum: LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT
- Topic: EGLK19264 VPT - No 5vcc on GPO header
- Replies: 1
- Views: 15165
- Wed May 08, 2024 6:35 pm
- Forum: LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT
- Topic: EGLK Stuck at bootloader
- Replies: 3
- Views: 21683
Re: EGLK Stuck at bootloader
Hello Raquel,
I am glad to say that your recommendation worked.
I had to try a second and better quality USB-to-RS232 I/F as the old Targus hub I used was not able to do the job.
Merci beaucoup!
Thanks,
I am glad to say that your recommendation worked.
I had to try a second and better quality USB-to-RS232 I/F as the old Targus hub I used was not able to do the job.
Merci beaucoup!
Thanks,
- Sun May 05, 2024 5:23 pm
- Forum: LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT
- Topic: EGLK Stuck at bootloader
- Replies: 3
- Views: 21683
EGLK Stuck at bootloader
My attempts to upgrade the firmware on my EGLK19264A-7T-FGW-VPT-PL from 8.5 to 8.6 using the application failed due to the PC unintentionally going into sleep mode during the process.
Power cycle will not restart the unit, it shows "Bootloader V1.0.5". When trying t send commands to it, the screen ...
Power cycle will not restart the unit, it shows "Bootloader V1.0.5". When trying t send commands to it, the screen ...