Hi Tom,

Well, I tried your suggestions but with no luck. I unistalled the LCD driver, removed the registry enteries, and tried another USB port. I even tried connecting to the LCD using the normal USB port instead of the alt. one, nothing... Any other ideas?

I really don't think it's the USB ...

I recently purchased the VK202-24-USB (Rev 1.4). I am using the fan headers, so I remove jumper 2 and connected a floppy cable power input. Everything works fine except when I shut my computer of for a while (power down or standby), then when I start it up the LCD dosen't seem to power up. The only ...

Jarrod,

I carefully unsoldered the resistor (component) located below the U and checked with a meter to make sure it was a open connection.
That's the only change I made and everything works fine.

Jay

What is the best way to mount the temp probes? I would like to mount them so their removeable and not perminately glued or fastened. I wanted to mount one to my ram, one to one of my harddrives, etc.. I was thinking maybe ATV silicon or something like that. I also have QuickSilver epoxy adhesive but ...

If you have soldering capability and feel confortable doing it, all you need to do is unsolder the the blob of solder where the U is in picture #2... nothing else. If you don't feel confortable soldering you could leave it as is. Unsoldering the jumper in #2 is the proper way of doing it.

Henry ...

Before I make the changes to my LK204-24-USB to power by a floppy cable I want to make sure I solder jumper 1 and remove the jumper 2 correctly. On the picture I drew a red line to show were to create a jumper and at jumper 2 am I suppost to remove the bridge where I drew the line?

Thanks for your ...