matrix orbital vs. chenming case

nethyr · Post by **nethyr** » Fri Jan 03, 2003 8:44 am

has anyone had any success with mounting a pcbay ready matrix orbital (like this):

into a chenming case which is made for use with drive rails and really wants to have nothing do with the MO's screws

(like this):

tnx for any help!

Pheonix · Post by **Pheonix** » Fri Jan 03, 2003 3:36 pm

if all else fails could you remove the drive rails and drill your own holes?

nethyr · Post by **nethyr** » Fri Jan 03, 2003 3:46 pm

yea its possible but i was hoping to find alternatives before raising a dremel to my drivecage

witcompe · Post by **witcompe** » Tue Jan 07, 2003 3:42 pm

Yes... I just got my Matrix Orbital (Same model pictured above, I am too lazy to type out the model numbers) and I have a chenming case and it works well... It is not a perfect fit, but it works... Just screw on the clips to either side and it slides right in with too much problems.