Hello,
I send a command use GTT support tool "Load Bitmap to Buffer" Index:10, Filename: c:\b1.jpg (254 95 10 99 58 92 98 49 46 106 112 103 0)
Also I receive the answer
"The specified filename was not found" (252 95 00 01 00)
Best Regards,
stm
That I do not so
Moderator: Mods
Hello stm,
I see a few common mistakes here, and I think I can help you out.
First, any images you wish to display must to be saved on the SD card connected to your GTT. You can do this via the onboard USB connector by powering up with the unit in mass storage mode.
When saving your images, keep things simple and don't use any folders. Also, take note of the file names and sizes.
Next, to load an image, make sure you are in communication mode, then reference the image by name only, without the file path.
That should do it, but if you have any more trouble, please don't hesitate to post.
Thanks,
~Troy
I see a few common mistakes here, and I think I can help you out.
First, any images you wish to display must to be saved on the SD card connected to your GTT. You can do this via the onboard USB connector by powering up with the unit in mass storage mode.
When saving your images, keep things simple and don't use any folders. Also, take note of the file names and sizes.
Next, to load an image, make sure you are in communication mode, then reference the image by name only, without the file path.
That should do it, but if you have any more trouble, please don't hesitate to post.
Thanks,
~Troy
Troy Clark
Design & Development
Matrix Orbital
Design & Development
Matrix Orbital