With the GLK12232-25-WBL I am working with, when I poll for the module type (254 & 55), the LCD is returning 0x08 instead of the 0x22 I expected... In the GLK12232-25 manuel, it says that the code for it should be "GLK12232-25 - 0x22", not the "LK202-25 - 0x08" that I am recieving. I recieve data perfectly well when uploading a bitmap, so I doubt that the serial communication is an issue but I'm a little confused at why it is sending 0x08 back at me.. Any help would be appreciated!
-special [k]
_________________
"An unsupervised teenager with a modem is as dangerous as an unsupervised teenager with a gun." -Arizona State Attorney Gail Thackeray
Chemical name: Cyclohexanone, 2-(2-chlorophenyl1)-(methylamino)-cyclohexanone hydrochloride, C13H16ClNO
<font size=-1>[ This Message was edited by: specialk on 2002-03-05 19:28 ]</font>
Read module type question for GLK12232-25-WBL
Well, from what I found out is the type number that should be loaded into the display here has not been done. So the LCD will not respond properly. The LCD can be loaded with a type. I'll look into this and see what I find.
http://www.matrixorbital.com/download/all_in_one.rar
try this...
_________________
Henry J.
Technical Support
Matrix Orbital
<font size=-1>[ This Message was edited by: Henry on 2002-03-06 13:43 ]</font>
http://www.matrixorbital.com/download/all_in_one.rar
try this...
_________________
Henry J.
Technical Support
Matrix Orbital
<font size=-1>[ This Message was edited by: Henry on 2002-03-06 13:43 ]</font>