RS232 Driven True vs Driven Inverted

Take a load off and chat!

Moderators: Henry, Mods

Post Reply
SaintAero
LCD?
Posts: 1
Joined: Wed Aug 15, 2012 6:42 pm

RS232 Driven True vs Driven Inverted

Post by SaintAero » Wed Aug 15, 2012 8:26 pm

I'm using a PIC16F688 with PICBASIC PRO Compiler to run a LCD2041 rev 1.5.
The RS232 TX output from the PIC is wired directly to the power connector pin 3. The 3 TTL connections are soldered closed. J3 is jumpered for 9600 baud, and the RS232 jumpers above the DB9 are installed.
This works fine as long as I set the RS232 output to "Driven True" (T9600 in PICBASIC)
Is there a method to run the LCD using RS232 "Driven Inverted" (N9600)?
Don

Raquel
Matrix Orbital
Matrix Orbital
Posts: 689
Joined: Thu Aug 19, 2004 3:37 pm
Location: MO Office

Re: RS232 Driven True vs Driven Inverted

Post by Raquel » Thu Aug 16, 2012 7:47 am

Hi Don,

Thank you for posting on the forum.

Unfortunately no, there is no way to communicate with the display using inverted serial data.
It is a neat feature found on some micro controllers that offer enhanced USART, but unfortunately the LCD2041 does not have this capability.

Best Regards,
Raquel Malinis
Design and Development
Matrix Orbital

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest