Electrical Specifications (General comment), I2C (Specific q

Take a load off and chat!

Moderators: Henry, Mods

Post Reply
KeepItSimpleStupid
LCD?
Posts: 4
Joined: Sat Nov 05, 2011 4:30 pm

Electrical Specifications (General comment), I2C (Specific q

Post by KeepItSimpleStupid » Sat Nov 05, 2011 5:01 pm

I've looked through a lot of your documentation and Vhigh and Vlow levels and sourcing and sinking currents don't seem to be well defined.

Can, for instance the I2C buss be pulled up to 3.3V or must 5V be used and level translators be employed?

PET PIEVE

My feeling is that any pin, that a customer is going to interface with, the customer needs to be provided with an EQUIVALENT CIRCUIT. Note, I did not say schematic.

Clark
Matrix Orbital
Matrix Orbital
Posts: 864
Joined: Fri Aug 17, 2007 10:58 am
Location: Matrix Orbital
Contact:

Post by Clark » Tue Nov 08, 2011 11:33 am

Hi Simple,

The Phillips I2C Standard states that the SCL and SDA lines "are pulled-up to the logic ‘high’ level by resistors connected to a single positive supply". That document also has a great deal of information regarding interfacing circuits that didn't fit into the Wikipedia article. It's a very informative read for anyone who wants to know a little more about employing an I2C protocol in their design.

Thanks,
~Troy
Troy Clark
Design & Development
Matrix Orbital

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests