Making a GTT Desktop Case

Take a load off and chat!

Moderators: Henry, Mods

Post Reply
Aniso
-=Beloved by all=-
-=Beloved by all=-
Posts: 282
Joined: Tue Aug 14, 2001 6:00 pm
Location: ...I could tell you my velocity...

Making a GTT Desktop Case

Post by Aniso » Fri Feb 24, 2017 2:35 pm

I was finishing a desktop case for a GTT module and wanted to demonstrate the process.

First I start with a 3D print of our case design. This first photo is after initial application of some Bondo. The specific Bondo product is "Glazing and Spot Putty" which is a one part paste full of VOCs and cancer which requires adequate ventilation. It sticks to the PLA of the print very well, but I do sand it to roughen it up first (and remove high spots).
20170130a.jpg
20170130a.jpg (844.27 KiB) Viewed 399 times
After application of Bondo, it is sanded on a flat surface. It is important to build up the Bondo against a flat reference. You can not "free sand" until the very final steps. After each sanding, the object is painted with sanding primer. I do this to provide a layer of color for sanding the next coat - when I see the primer exposed, I know that I need to stop sanding. This shows the painted piece.
20170201_150832.jpg
20170201_150832.jpg (798.52 KiB) Viewed 399 times
Next more Bondo is applied.
20170201_163419.jpg
20170201_163419.jpg (720.99 KiB) Viewed 399 times
This is then carefully sanded bit by bit until as much Bondo is removed as possible without sanding beyond the previous layer.
20170201_174154.jpg
20170201_174154.jpg (955.04 KiB) Viewed 399 times
This process is repeated until all the low spots have been filled.
20170203_130038.jpg
20170203_130038.jpg (809.16 KiB) Viewed 399 times
20170204_153343.jpg
20170204_153343.jpg (719.21 KiB) Viewed 399 times
20170204_201939.jpg
20170204_201939.jpg (767.99 KiB) Viewed 399 times
And this is the piece just before the final (or second final) application of sanding primer.
20170204_224922.jpg
20170204_224922.jpg (713.83 KiB) Viewed 399 times
After this, the piece is sanded one last time with very fine (800) sandpaper and painted with color. I should continue this thread and fill in details. Any interest?

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest