Page 1 of 1

the last block on display fuzzy

Posted: Sun Sep 28, 2008 8:28 pm
by ROTENJALAPENO
I am currently working with MOP-AL204A-BGFW-25E-3IN and I using a propeller chip to drive it. I have everything set up and everything is working great and flawlessly except whenever I try to write a character in the last block DDRAM ADDRESS($67)
it turns character fuzzy, and/or only partially displayed. It also affects the char before it ($66). It seems like there is a faint ghost image from the other block. I am just wondering what could possibly do this. I tried several different initalization configurations and I still cannot get the last block to display correctly. Any suggestions would be greatly appreciated!
Thanks,
Jeremy

Posted: Mon Sep 29, 2008 6:33 am
by Ray
Could you post a picture of this effect you are seeing?