Hello,
I recently purchased a MOP-GL240128D-BWFW-12N-3IY display that I connected to my GLK240128-25-GW rev1.1 interface PCB. I was communicating with the assembly just fine using the MOGD# v1.1.6 software when suddenly I was unable to change any settings or even connect to the device. I'm using RS-232 and have the jumpers installed correctly. I turn on my power supply with +5V and the display comes on. I hit 'auto detect display' in the software and a message pops up that says 'no displays found'. I've been stuck here for 2 days and cannot figure out what the heck is going on. I was told by tech support that this would be a 'plug and play' option where I would just have to hook my two assemblies together and I would be good to go. I cannot do anything and it is very frustrating. Any help is greatly appreciated.
Thank you,
Tucker
GLK240128-25-GW Connection issues
Re: GLK240128-25-GW Connection issues
Hi Tucker,
From your email, it sounds like manual override has helped you resolve this issue. If you have any further trouble please don't hesitate to ask.
Cheers,
Troy
From your email, it sounds like manual override has helped you resolve this issue. If you have any further trouble please don't hesitate to ask.
Cheers,
Troy
Troy Clark
Design & Development
Matrix Orbital
Design & Development
Matrix Orbital