no fan control yet

LK/ELK/VK/PK/OK/MX/GLK/EGLK/GVK/GLT Series

Moderators: Henry, Mods

Post Reply
firehorse
LCD Geek
Posts: 32
Joined: Sat Aug 07, 2010 9:58 pm

no fan control yet

Post by firehorse »

Hi,
please note:
I am registered with LCDC but cannot post a topic..I tried my usual login but the account didnt exist ????? So I re registered again but still cant post. No reply from admin

Its been a week

So I decides to post here, at least confirm I have the hardware setup the right way

ok,
LK202-24-USB

selected the GPO HIGH power option with the little black square thing (bridge?)
on the 3 pin header, to the left side

plugged in the floppy power cable 12v, com,com, 5v (DMM says 12v)

plugged in fan to GPO header #1 (at the top)

DOW is plugged in and works perfectly temps are spot on (using the DS18"B"20 rather than the DS1820) address is displayed correctly

then went to:
GPO/RPM control menu in LCDC:

set GPO number to 1
set to report rpm ie:ticked the box
divider set to 1
Advanced Control set to = manual,set in screen builder
Start/Stop setting set to = 50

In screen builder :

Name = Fan1
Event = On D1W Temperature "Gt Or Eq"
Probe & Temp = 230.Dallas Temp Test temp = 30

Post Reply