Matrix Orbital Temperature Probe:
there is way to use Bitspower G 1/4in. Temperature Sensor Stop Fitting??
http://ep.yimg.com/ca/I/sidewindercompu ... 3_22151905
i want to install it into EK-Multioption RES 250 rev.2 Reservoirs
mx630 , there is way to install water sensor?
Hi Pelo911,
If you're set on using your MX display and the Dallas One-Wire sensor for this project, you could attempt to waterproof the sensor with an epoxy and place it in your reservoir. This is not a standard application of the device and I would highly recommend doing extensive testing before placing it in your computer. Matrix Orbital of course cannot be responsible for any damage resulting from the set up.
~Troy
If you're set on using your MX display and the Dallas One-Wire sensor for this project, you could attempt to waterproof the sensor with an epoxy and place it in your reservoir. This is not a standard application of the device and I would highly recommend doing extensive testing before placing it in your computer. Matrix Orbital of course cannot be responsible for any damage resulting from the set up.
~Troy
Troy Clark
Design & Development
Matrix Orbital
Design & Development
Matrix Orbital