Okay now it's making sense.

I did think it odd that the "1" command was turning it "off".

Thanks for the clarification.

Right, so 0xFE /*Command*/ 0x7E /*Set Auto Repeat*/ 0x01 /*Off*/ should have the same effect as: 0xFE /*Command*/ 0x60 /*Auto Repeat Off*/ Correct? What's bothering me is that the behavior I'm seeing is that the top command works, and turns the auto repeat off, but the bottom command does not (I don...

Thanks for the response. I actually figured it out a couple hours ago but didn't update the post yet. Using the "Set Auto Repeat" command rather than the "Auto Repeat Mode Off" command worked. 0xFE /*Command*/ 0x7E /*Set Auto Repeat*/ 0x01 /*Off*/ So now I guess the followup ques...

Hi all, I started a thread last week regarding the keypad returning keypresses. The problem ended up being solved, I was not configuring correctly (protocol was not set to I2C in software). I'm now trying to program some simple key press/release code for repeating events upon holding a key. I am con...

However it was NOT being set in software. That fixed the issue. 0x50 0xFE 0xA0 0x00 I was under the impression only the jumpers would need to be set. A note to anyone from Matrix, the documentation for this display could make it a bit clearer that both the jumpers need to be set as well as the softw...

Yes, the jumpers are set to I2C

Hi all, I'm working on getting a LK204-7T-1U running and while most everything is working the one issue I'm having is with polling the keypad. I am working through an I2C interface and I am sending what I believe to be the correct configuration commands. I am sending the following: (See screencap at...